15 Νοέ UMELINE FAQs 2 – Network Settings

How does the camera establish a hotspot pattern

1. The default connection mode is AP hotspot mode For a device whose default connection mode is AP hotspot mode, hold down the camera reset button to restore the default Settings. The device will be in AP hotspot mode The device has a voice prompt: “Restore factory defaults” – “Access point ready” – “Access Point ready” If the mobile phone WiFi list can search for the hotspot signal beginning with MV, it indicates that the hotspot has been successfully opened and established

2. Devices whose default connection mode is station mode Devices whose default connection mode is station mode, no matter what state the device is in (except network cable), long press the camera reset button to restore the factory default Settings will be in the wifi smart connection configuration The status tape speaker will have a voice prompt: “Restore factory default Settings” – “Wait for WiFi smartlink configuration” Press the reset button again to switch to the AP hotspot mode. The device voice prompts: “Access point ready” – “Access point ready” If the hotspot signal can be found in the mobile phone WiFi list beginning with MV, the hotspot has been successfully established

Note: When the camera is connected to a network cable, the wireless connection mode is blocked. Restoring factory default Settings does not change the network connection status of the device